OL stands for “Over Limit” or “Open Loop”, depending on the multimeter manufacturer. It generally indicates that the measured resistance is beyond the meter’s range or that the electrical path is open.
1. OL in Resistance Mode
When measuring resistance, an OL reading usually indicates very high or infinite resistance.
Common reasons:
- Broken or disconnected wire
- Blown fuse
- Open switch
- Loose terminal connection
- Damaged component
Example If you measure a disconnected or broken wire in resistance mode, the multimeter may display OL.
2. OL in Continuity Mode
In continuity mode, OL generally means there is no continuous electrical path between the two test probes.
- Beep: Electrical continuity is present.
- OL: No continuity is detected.
3. OL vs 0 Ω Reading
| Multimeter Reading | Meaning |
|---|---|
| OL | Open path or resistance beyond range |
| 0 Ω | Very low resistance |
| 10 Ω | Low resistance |
| 1 kΩ | 1,000 ohms |
4. How to Check an Open Circuit
- Switch OFF and isolate the power supply.
- Verify that the circuit is de-energized.
- Set the multimeter to continuity or resistance mode.
- Place the probes across the wire or component.
- Check the display.
If the meter displays OL, inspect the wiring, terminals, fuse, or component for an open connection.
Important: Never perform resistance or continuity measurements on an energized circuit.
Leave a Reply