A plinth is a square or rectangular metal base used to support an enclosure. Plinths are used to elevate (lift up) an enclosure to facilitate service access or reduce the risk of flooding at the installation site. Plinths can be… Continue Reading →
Comb busbar is one of the most basic switch gear equipment. A comb busbar is to distribute power to switch gear components such as MCBs.The main purpose of using comb busbar is to reduce the number of wire connections and… Continue Reading →
DIN rails are the metal rails inside an electrical enclosure that are used to mount electrical equipment.These electrical components require solid mechanical support to ensure that they remain in place and function correctly. However, they’re usually not designed to be mounted… Continue Reading →
A media converter is a networking device that converts Ethernet or other communication protocols from one cable type to another, typically fiber to copper CATx/UTP.
TB Modular Terminal blocks are designed to connect two wires for extreme durability even under tough temperature conditions. Terminal blocks are connectors that terminate a wire and connect it to a circuit or other system, Using terminal blocks is a… Continue Reading →
What is wire labeling?Why should we use them? What is wire labeling? Wire marking is when you label, or mark, all wires with information like where is it coming from and where to go. Why should we use them?… Continue Reading →
Why do we need testing in the control room?Test Plans for the Control Panel Why do we need testing in the control panel? Panel testing is very important step in electrical projects; if we skip it or do not do… Continue Reading →
Panel testing is very important step in electrical projects; if we skip it or do not do it properly then we may face many issues at the time of installation.Example : Missing or wrong ferrule Missing Components labelsLoose Wiring TerminationWrong… Continue Reading →
•What is Multimeter ? •Type of Multimeter • Multimeter Function & Use MULTIMETER HISTORY : The first device that can be considered the predecessor of the multimeter was in 1820. That instrument was the galvanometer. These were used to measure… Continue Reading →
Introduction of GOC 35 and 43.IO Quant of GOC 35 and 43.Field Connection with GOC. Introduction of GOC 35 and 43 Graphic Operation Controller 35Graphic Operation Controller(GOC 35) has been designed PLC with an inbuilt HMIAnnunciator and PB lamps, customizable… Continue Reading →
© 2025 Electrical Hungry Minds